APC Smart-UPS SC450 450VA 280W 230V 1 Phase 4x C13. UPS Rack 1U SC450RMI1U. New Open – Never Used. Supplied With Rack Ears, Brackets And Serial Comms Cable. APC Smart-UPS SC450 450VA 280W 230V 1 Phase 4x C13 UPS Rack 1U SC450RMI1U. APC Smart-UPS SC is ideal for small and medium businesses looking to protect entry-level servers and networking equipment from power disturbances and outages. The Smart-UPS SC features network grade runtime, hot swap batteries, and built-in data line protection for worry free uninterruptible power protection for increased availability. Most Smart-UPS SC models can be installed in either a tower or rack configuration, allowing standardisation across multiple applications. Built on the same standards as the award-winning Smart-UPS, with over 10 million installed, Smart-UPS SC provides the basic features and manageability needed to protect entry-level applications. Run time for load 280W – 5m. Output power capacity: 280Watts / 450VA. Output Connections: (4) IEC 320 C13 (Battery Backup). Nominal Output Voltage: 230V. Nominal Input Voltage: 230V. Input Connections: IEC-320 C14. Smart-UPS Features & Benefits. LED status indicators – Quickly understand unit and power status with visual indicators. USB connectivity – Provides management of the UPS via a USB port (not available on all models). Serial connectivity – Provides management of the UPS via a serial port. Network manageable – Most models provide remote power management options of the UPS over the network. Many do not have NMC embedded. Audible alarms – Actively let you know if the unit is on battery, if the battery is low or if there is an overload condition. Disconnected battery notification – Warns when a battery is not available to provide backup power. Intelligent battery management – Maximizes battery performance, life, and reliability through intelligent, precision charging. Power conditioning – Protects connected loads from surges, spikes, lightning, and other power disturbances. Temperature-compensated battery charging – Prolongs battery life by regulating the charge voltage according to battery temperature. Automatic restart of loads after UPS shutdown – Automatically starts up the connected equipment upon the return of utility power. Automatic self-test – Periodic battery self-test ensures early detection of a battery that needs to be replaced. Boost and Trim Automatic Voltage Regulation (AVR) – Gives higher application availability by correcting low and high voltage conditions without using the battery (not available on all models). Adjustable voltage sensitivity – Provides the ability to adapt the UPS for optimal performance in specific power environments or generator applications. Adjustable voltage-transfer points – Maximizes useful battery life by widening the input voltage window or tightening the output voltage regulation. Battery failure notification – Provides early-warning fault analysis on batteries enabling timely preventive maintenance. Resettable circuit breakers – Enables a quick recovery from overload events. Predictive failure notification – Provides early-warning fault analysis ensuring proactive component replacement. Hot-swappable batteries – Ensures clean, uninterrupted power to protected equipment while batteries are being replaced. User-replaceable batteries – Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR). Max Configurable Power (Watts): 280Watts / 450VA. Output Voltage Distortion: Less than 5% at full load. Output Frequency (sync to mains): 47 – 53 Hz for 50 Hz nominal, 57 – 63 Hz for 60 Hz nominal. Waveform type: Stepped approximation to a sinewave. Transfer Time: 4ms typical : 8ms maximum. Input frequency: 50/60 Hz +/- 3 Hz (auto sensing). Input voltage range for main operations: 195 – 265V. Input voltage adjustable range for mains operation: 151 – 302V. Battery type: Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof. Typical recharge time: 5hour(s). Expected Battery Life (years): 3 – 5. Battery Charge Power (Watts): 22Watts. Battery Volt-Amp-Hour Capacity: 108. Interface Port(s): DB-9 RS-232. Control panel: LED status display with On Line : On Battery : Replace Battery and Overload indicators. Audible Alarm: Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm. Emergency Power Off (EPO): Optional. Surge Protection and Filtering. Data Line Protection: RJ-11 2-Way Modem/Fax/DSL splitter with protection (four wire dual lines), RJ45 10/100 Base-T Ethernet protection. Filtering: Full time multi-pole noise filtering : 0.7% IEEE surge let-through : zero clamping response time : meets UL 1449. Maximum Height: 44MM, 4.4CM. Maximum Width: 432MM, 43.2CM. Maximum Depth: 383MM, 38.3CM. Net Weight: 10.18KG. Operating Temperature: 0 – 40 °C. Operating Relative Humidity: 0 – 95 %. Storage Temperature: -15 – 45 °C. Storage Relative Humidity: 0 – 95 %. Audible noise at 1 meter from surface of unit: 38.0dBA. Online thermal dissipation: 38.0BTU/hr. VAT IS NOT PAYABLE BY PURCHASERS OUTSIDE THE European Union (EU) AND. By purchasers in the EU (excluding UK) who are VAT registered. The item “APC Smart-UPS SC450 450VA 280W 230V 1 Phase 4x C13 UPS Rack 1U SC450RMI1U” is in sale since Saturday, June 20, 2020. This item is in the category “Computers/Tablets & Networking\Power Protection, Distribution\Power Distribution Units”. The seller is “itinstock” and is located in London. This item can be shipped worldwide.

• Model: Smart UPS 450
• Colour: Black
• Item Height: 44mm
• Item Width: 432mm
• Compatible Brand: For APC
• Number of Outlets: 4 x IEC 320 C13
• Type: Uninterruptible Power Supply (UPS)
• Features: Audible Alarm
• Surge Energy Capacity: 320 J
• Maximum Power: 280 W
• MPN: SC450RMI1U
• Item Length: 383mm
• Cable Length: 1.83m
• Output Power Capacity: 450VA
• Input Connections: IEC-320 C13
• Brand: APC
• Form Factor: Rackmount 1U
• Voltage Compatibility: 230 V
• Maximum Wattage: 280W